Orca v0.40 Kit with Linear Bearings

This kit contains all that you need, to make a fully working Orca v0.40 3D printer. This kit comes standard with additional items such as: kapton tapes, heated bed for ABS & PLA, power supply, usb cable, few mtr PLA etc to make sure it’s a complete kit.

• Overall size 38.2 x 38.75 x 36.93 cm
• Build size 22 x 22 x 16.5 cm

Lead time: 2-3 weeks

This complete Orca v0.40 kit contains :

CLICK HERE TO DOWNLOAD MANUAL CONTAINING A LIST OF ITEMS INCLUDED IN OUR ORCA v0.40 COMPLETE KIT

• Generation 6 Electronics - including opto's on correct cable lengths with molex connectors and high temp heat cables for connecting Heater and Thermistor
• All hardware cut bearings, bars, studding & bolts, nuts, washers, Linear Bearings etc
• All aluminium cut sheets (Z bearing support, Side plates, Bottom plate, Top plate, Middle plate, Y-side frame, Y-side support, Y-motor plate, Y-frog, Extruder base, Extruder motor plate, Heated printbed and opto-flags)
• M8 Threaded rods (330 and 400mm)
• Chrome plated Smooth rods (330 and 400mm)
• Printed plastic parts - Orca v0.30 plastic set (Pulleys, Clamps, Holder, Extra fan support, etc) & Extruder plastics for Hotend v9 
• Motor set of 4 - including correct cable lengths and Molex connectors (plug and play with Gen6 electronics)
• M4 Brass insert piece - for direct drive on motor shaft (5.1mm inner diameter)
• Hot end v9 partially pre-assembled, including Heater block, G550 Thermistor, Heat Resistor, Cooling fan, etc
• Silicone sealant (used for placing Thermistor and Resistor in Heater block)
• Kapton tape 15mm (Insulation of Thermistor legs)
• Kapton tape 40mm (To print on)
• Set of 4 Heater blocks, 4 x 1.0 Ohm (for Heated printbed)
• Cooling paste (To use between Printbed and Heater blocks)
• PTFE strain-relief
• X, Y and Z belts for Orca v0.40
• Power Supply 96W, Input: AC 100-240V, 50-60Hz, 1.3A, Output: DC 15V~20V, 3.5A
• USB and Power supply cables
• Plastic tie
• Extras such as Optos, Magnetic leveler, Forceps, Few mtr of PLA for first tests, etc